The WebYaST module displays status information
collected by the collectd daemon, for example:
CPU, memory and disk usage, network interface status, and system load.
The specific data shown may be different in your appliance.
For each type of data, it is possible to set limits - the minimum and the maximum value allowed. If the actual value exceeds this limits, the system is considered unhealthy and the health indicator in the control panel turns red, see Section 3.2, “The System Status Area”.
To set the limit values, follow these steps:
Log into the WebYaST interface of the target system and start the module.
Click at the bottom of the screen.
For each type of data, you can set the
and the in the units used by
collectd.
Click and .