This is a "plugin" for the Video Disk Recorder (VDR).

Written by:                  Thomas Bergwinkl <Thomas.Bergwinkl@t-online.de>

See the file COPYING for license information.

Description:
With this plugin you can control a diseqc motor.

In the setup-menu of the plugin you have to select the card which is connected with the motor. For the GotoX-function you have to set the right values for latitude and longitude. 

In the plugin-menu you see on the top the signalstrength of the currently tuned channel. 

Drive East 	: starts driving the rotor eastwards
Drive West 	: starts driving the rotor west
Halt	    	: stopps any movement of the rotor
Recalc (xx)	: recalculates all stored positions according to the given position
Goto xx    	: rotor drives to position number xx
Store xx   	: the current position will be stored to position number xx	
XX Steps East	: rotor moves XX steps eastwards
XX Steps West	: rotor moves XX steps westwards

If you want to use the GotoXX.X funtion you have to select the satellite you want to aim to (e.g. "S13.0E - Hotbird 1-(5)-6") and then press OK. But this can, of course, only work, when the right values for longitude and latitude (of your location) are configured in the setup menu. If your rotor isn't adjusted correctly to "true south" you can try a little bit different values for longitude. 

Frequency & Symbolrate: Here you can select a frequency, polarization (by pressing left/right) and symbolrate you want to tune to (by pressing OK) and see what signal-strength you get there. To this transponder will also be tuned to, after commands like store, goto , drive east, ...

Scan Transponder (only vdr-1.3.x): If you press OK on Scan Transponder, vdr will switch to the selected transponder and scan for new/updated channels.

It is also possible to use the GotoX function on channel switch instead of the commands in diseqc.conf (without patching vdr). For this you have to enable the "Use GotoX on channel switch" option in the setup menu.
But there is also a patch included if you want to use the GotoX function without the plugin.

If "Show Info on channel switch" is enabled a message is shown during the rotation of the dish. 
